1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR
= ..
/..
/tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
15 # To use own keymap file run make like: make keymap=hasu
17 SRC
+= keymap_
$(KEYMAP
).c
19 SRC
+= keymap_default.c
25 # MCU name, you MUST set this to match the board you are using
26 # type "make clean" after changing this, so all files will be rebuilt
27 MCU
= atmega32u2
# TMK converter rev2
28 #MCU = atmega32u4 # TMK converter rev1
31 # Processor frequency.
32 # Normally the first thing your program should do is set the clock prescaler,
33 # so your program will run at the correct speed. You should also set this
34 # variable to same clock speed. The _delay_ms() macro uses this, and many
35 # examples use this variable to calculate timings. Do not add a "UL" here.
42 # Target architecture (see library "Board Types" documentation).
45 # Input clock frequency.
46 # This will define a symbol, F_USB, in all source code files equal to the
47 # input clock frequency (before any prescaling is performed) in Hz. This value may
48 # differ from F_CPU if prescaling is used on the latter, and is required as the
49 # raw input clock is fed directly to the PLL sections of the AVR for high speed
50 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
51 # at the end, this will be done automatically to create a 32-bit value in your
54 # If no clock division is performed on the input clock inside the AVR (via the
55 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
58 # Interrupt driven control endpoint task
59 OPT_DEFS
+= -DINTERRUPT_CONTROL_ENDPOINT
62 # Boot Section Size in bytes
64 # Atmel DFU loader 4096
65 # LUFA bootloader 4096
66 OPT_DEFS
+= -DBOOTLOADER_SIZE
=4096
70 # *Comment out* to disable the options.
72 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
73 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
74 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
75 CONSOLE_ENABLE
= yes
# Console for debug(+400)
76 COMMAND_ENABLE
= yes
# Commands for debug and configuration
77 #SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
78 #NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
79 #KEYMAP_SECTION_ENABLE = yes # fixed address keymap for keymap editor
83 #---------------- Programming Options --------------------------
84 PROGRAM_CMD
= teensy_loader_cli
-mmcu
=$(MCU
) -w
-v
$(TARGET
).hex
88 VPATH
+= $(TARGET_DIR
)
92 include $(TMK_DIR
)/protocol
/lufa.mk
93 include $(TMK_DIR
)/protocol.mk
94 include $(TMK_DIR
)/common.mk
95 include $(TMK_DIR
)/rules.mk