# # Makefile for V-USB # # Target file name (without extension). TARGET = ps2_usb_vusb # Directory common source filess exist TOP_DIR = ../.. # Directory keyboard dependent files exist TARGET_DIR = . # keyboard dependent files SRC = main.c \ keymap.c \ matrix.c \ led.c \ ps2_usart.c CONFIG_H = config_vusb.h # V-USB debug level: To use ps2_usart.c level must be 0 # ps2_usart.c requires USART to receive PS/2 signal. OPT_DEFS = -DDEBUG_LEVEL=0 # MCU name, you MUST set this to match the board you are using # type "make clean" after changing this, so all files will be rebuilt #MCU = at90usb162 # Teensy 1.0 #MCU = atmega32u4 # Teensy 2.0 #MCU = at90usb646 # Teensy++ 1.0 #MCU = at90usb1286 # Teensy++ 2.0 MCU = atmega168 # Processor frequency. # Normally the first thing your program should do is set the clock prescaler, # so your program will run at the correct speed. You should also set this # variable to same clock speed. The _delay_ms() macro uses this, and many # examples use this variable to calculate timings. Do not add a "UL" here. F_CPU = 20000000 # Build Options # comment out to disable the options. # MOUSEKEY_ENABLE = yes # Mouse keys EXTRAKEY_ENABLE = yes # Audio control and System control #NKRO_ENABLE = yes # USB Nkey Rollover NO_UART = yes # UART is unavailable #---------------- Programming Options -------------------------- AVRDUDE = avrdude # Type: avrdude -c ? to get a full listing. AVRDUDE_PROGRAMMER = usbasp AVRDUDE_PORT = AVRDUDE_WRITE_FLASH = -U flash:w:$(TARGET).hex #AVRDUDE_WRITE_EEPROM = -U eeprom:w:$(TARGET).eep # Uncomment the following if you want avrdude's erase cycle counter. # Note that this counter needs to be initialized first using -Yn, # see avrdude manual. #AVRDUDE_ERASE_COUNTER = -y # Uncomment the following if you do /not/ wish a verification to be # performed after programming the device. #AVRDUDE_NO_VERIFY = -V # Increase verbosity level. Please use this when submitting bug # reports about avrdude. See # to submit bug reports. #AVRDUDE_VERBOSE = -v -v #AVRDUDE_FLAGS = -p $(MCU) -P $(AVRDUDE_PORT) -c $(AVRDUDE_PROGRAMMER) AVRDUDE_FLAGS = -p $(MCU) -c $(AVRDUDE_PROGRAMMER) AVRDUDE_FLAGS += $(AVRDUDE_NO_VERIFY) AVRDUDE_FLAGS += $(AVRDUDE_VERBOSE) AVRDUDE_FLAGS += $(AVRDUDE_ERASE_COUNTER) PROGRAM_CMD = $(AVRDUDE) $(AVRDUDE_FLAGS) $(AVRDUDE_WRITE_FLASH) $(AVRDUDE_WRITE_EEPROM) include $(TOP_DIR)/protocol/vusb.mk include $(TOP_DIR)/protocol.mk include $(TOP_DIR)/common.mk include $(TOP_DIR)/rules.mk