1 # Target file name (without extension).
4 # Directory common source filess exist
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
19 # MCU name, you MUST set this to match the board you are using
20 # type "make clean" after changing this, so all files will be rebuilt
21 #MCU = at90usb162 # Teensy 1.0
22 MCU = atmega32u4 # Teensy 2.0
23 #MCU = at90usb646 # Teensy++ 1.0
24 #MCU = at90usb1286 # Teensy++ 2.0
27 # Processor frequency.
28 # Normally the first thing your program should do is set the clock prescaler,
29 # so your program will run at the correct speed. You should also set this
30 # variable to same clock speed. The _delay_ms() macro uses this, and many
31 # examples use this variable to calculate timings. Do not add a "UL" here.
38 # Target architecture (see library "Board Types" documentation).
41 # Input clock frequency.
42 # This will define a symbol, F_USB, in all source code files equal to the
43 # input clock frequency (before any prescaling is performed) in Hz. This value may
44 # differ from F_CPU if prescaling is used on the latter, and is required as the
45 # raw input clock is fed directly to the PLL sections of the AVR for high speed
46 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
47 # at the end, this will be done automatically to create a 32-bit value in your
50 # If no clock division is performed on the input clock inside the AVR (via the
51 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
54 # Interrupt driven control endpoint task
55 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
58 # Boot Section Size in bytes
60 # Atmel DFU loader 4096
61 # LUFA bootloader 4096
62 OPT_DEFS += -DBOOTLOADER_SIZE=4096
66 # comment out to disable the options.
68 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
69 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
70 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
71 CONSOLE_ENABLE = yes # Console for debug(+400)
72 COMMAND_ENABLE = yes # Commands for debug and configuration
73 #SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
74 #NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
78 #---------------- Programming Options --------------------------
79 PROGRAM_CMD = teensy_loader_cli -mmcu=$(MCU) -w -v $(TARGET).hex
83 VPATH += $(TARGET_DIR)
87 include $(TOP_DIR)/protocol/lufa.mk
88 include $(TOP_DIR)/protocol.mk
89 include $(TOP_DIR)/common.mk
90 include $(TOP_DIR)/rules.mk