1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?
= ..
/..
/tmk_core
7 # Directory keyboard dependent files exist
10 # project specific files
13 protocol
/serial_uart.c
19 # atmega32u4 Teensy2.0
20 # atemga32u4 TMK Converter rev.1
21 # atemga32u2 TMK Converter rev.2
24 # Processor frequency.
25 # This will define a symbol, F_CPU, in all source code files equal to the
26 # processor frequency in Hz. You can then use this symbol in your source code to
27 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
28 # automatically to create a 32-bit value in your source code.
30 # This will be an integer division of F_USB below, as it is sourced by
31 # F_USB after it has run through any CPU prescalers. Note that this value
32 # does not *change* the processor frequency - it should merely be updated to
33 # reflect the processor speed set externally so that the code can use accurate
41 # Target architecture (see library "Board Types" documentation).
44 # Input clock frequency.
45 # This will define a symbol, F_USB, in all source code files equal to the
46 # input clock frequency (before any prescaling is performed) in Hz. This value may
47 # differ from F_CPU if prescaling is used on the latter, and is required as the
48 # raw input clock is fed directly to the PLL sections of the AVR for high speed
49 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
50 # at the end, this will be done automatically to create a 32-bit value in your
53 # If no clock division is performed on the input clock inside the AVR (via the
54 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
57 # Interrupt driven control endpoint task(+60)
58 OPT_DEFS
+= -DINTERRUPT_CONTROL_ENDPOINT
61 # Boot Section Size in *bytes*
63 # Teensy++ halfKay 1024
64 # Atmel DFU loader 4096 for TMK Converter rev.1/rev.2
65 # LUFA bootloader 4096
67 OPT_DEFS
+= -DBOOTLOADER_SIZE
=4096
71 # comment out to disable the options.
73 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
74 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
75 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
76 CONSOLE_ENABLE
= yes
# Console for debug(+400)
77 COMMAND_ENABLE
= yes
# Commands for debug and configuration
79 #ACTIONMAP_ENABLE = yes # Use 16bit actionmap instead of 8bit keymap
80 #KEYMAP_SECTION_ENABLE = yes # fixed address keymap for keymap editor
86 ifeq (yes
,$(strip $(UNIMAP_ENABLE
)))
89 ifeq (yes
,$(strip $(ACTIONMAP_ENABLE
)))
90 KEYMAP_FILE
= actionmap
96 SRC
:= $(KEYMAP_FILE
)_
$(KEYMAP
).c
$(SRC
)
98 SRC
:= $(KEYMAP_FILE
).c
$(SRC
)
103 VPATH
+= $(TARGET_DIR
)
106 include $(TMK_DIR
)/protocol
/lufa.mk
107 include $(TMK_DIR
)/protocol.mk
108 include $(TMK_DIR
)/common.mk
109 include $(TMK_DIR
)/rules.mk