1 # Target file name (without extension).
4 # Directory common source filess exist
7 # Directory keyboard dependent files exist
10 # project specific files
11 SRC
= keymap_common.c \
16 SRC
:= keymap_
$(KEYMAP
).c
$(SRC
)
18 SRC
:= keymap_plain.c
$(SRC
)
28 # Processor frequency.
29 # This will define a symbol, F_CPU, in all source code files equal to the
30 # processor frequency in Hz. You can then use this symbol in your source code to
31 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
32 # automatically to create a 32-bit value in your source code.
34 # This will be an integer division of F_USB below, as it is sourced by
35 # F_USB after it has run through any CPU prescalers. Note that this value
36 # does not *change* the processor frequency - it should merely be updated to
37 # reflect the processor speed set externally so that the code can use accurate
45 # Target architecture (see library "Board Types" documentation).
48 # Input clock frequency.
49 # This will define a symbol, F_USB, in all source code files equal to the
50 # input clock frequency (before any prescaling is performed) in Hz. This value may
51 # differ from F_CPU if prescaling is used on the latter, and is required as the
52 # raw input clock is fed directly to the PLL sections of the AVR for high speed
53 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
54 # at the end, this will be done automatically to create a 32-bit value in your
57 # If no clock division is performed on the input clock inside the AVR (via the
58 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
61 # Interrupt driven control endpoint task(+60)
62 OPT_DEFS
+= -DINTERRUPT_CONTROL_ENDPOINT
65 # Boot Section Size in *bytes*
67 # Teensy++ halfKay 1024
68 # Atmel DFU loader 4096
69 # LUFA bootloader 4096
71 OPT_DEFS
+= -DBOOTLOADER_SIZE
=4096
75 # comment out to disable the options.
77 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
78 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
79 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
80 CONSOLE_ENABLE
= yes
# Console for debug(+400)
81 COMMAND_ENABLE
= yes
# Commands for debug and configuration
82 NKRO_ENABLE
= yes
# USB Nkey Rollover - not yet supported in LUFA
87 #PS2_USE_USART = yes # uses hardware USART engine for PS/2 signal receive(recomened)
88 #PS2_USE_INT = yes # uses external interrupt for falling edge of PS/2 clock pin
89 PS2_USE_BUSYWAIT
= yes
# uses primitive reference code
92 # Optimize size but this may cause error "relocation truncated to fit"
93 #EXTRALDFLAGS = -Wl,--relax
96 VPATH
+= $(TARGET_DIR
)
99 include $(TOP_DIR
)/protocol.mk
100 include $(TOP_DIR
)/protocol
/lufa.mk
101 include $(TOP_DIR
)/common.mk
102 include $(TOP_DIR
)/rules.mk