]>
git.gir.st - tmk_keyboard.git/blob - converter/xt_usb/Makefile
4 # Target file name (without extension).
7 # Directory common source filess exist
8 TMK_DIR
= ..
/..
/tmk_core
10 # Directory keyboard dependent files exist
13 # project specific files
18 SRC
:= keymap_
$(KEYMAP
).c
$(SRC
)
20 SRC
:= keymap_plain.c
$(SRC
)
30 # Processor frequency.
31 # This will define a symbol, F_CPU, in all source code files equal to the
32 # processor frequency in Hz. You can then use this symbol in your source code to
33 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
34 # automatically to create a 32-bit value in your source code.
36 # This will be an integer division of F_USB below, as it is sourced by
37 # F_USB after it has run through any CPU prescalers. Note that this value
38 # does not *change* the processor frequency - it should merely be updated to
39 # reflect the processor speed set externally so that the code can use accurate
47 # Target architecture (see library "Board Types" documentation).
50 # Input clock frequency.
51 # This will define a symbol, F_USB, in all source code files equal to the
52 # input clock frequency (before any prescaling is performed) in Hz. This value may
53 # differ from F_CPU if prescaling is used on the latter, and is required as the
54 # raw input clock is fed directly to the PLL sections of the AVR for high speed
55 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
56 # at the end, this will be done automatically to create a 32-bit value in your
59 # If no clock division is performed on the input clock inside the AVR (via the
60 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
63 # Interrupt driven control endpoint task(+60)
64 #OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
67 # Boot Section Size in *bytes*
69 # Teensy++ halfKay 1024
70 # Atmel DFU loader 4096
71 # LUFA bootloader 4096
73 OPT_DEFS
+= -DBOOTLOADER_SIZE
=512
77 # comment out to disable the options.
79 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
80 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
81 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
82 CONSOLE_ENABLE
= yes
# Console for debug(+400)
83 COMMAND_ENABLE
= yes
# Commands for debug and configuration
84 NKRO_ENABLE
= yes
# USB Nkey Rollover
89 XT_USE_INT
= yes
# uses external interrupt for falling edge of PS/2 clock pin
92 # Optimize size but this may cause error "relocation truncated to fit"
93 #EXTRALDFLAGS = -Wl,--relax
96 VPATH
+= $(TARGET_DIR
)
99 include $(TMK_DIR
)/protocol.mk
100 include $(TMK_DIR
)/protocol
/lufa.mk
101 include $(TMK_DIR
)/common.mk
102 include $(TMK_DIR
)/rules.mk